The QOMO bubbler only needs a small amount of water to function. In order to fill it up, I recommend using a slight trickle from your sink’s tap. Only fill up to the red fill line - if you fill over that line, the bubbler may splash during use. Once your bubbler is filled, place it back on the device and load the bucket with your material.
Once your material is loaded, place the carb cap on the vapor dome and power it on with three clicks of the power button. The device’s charging light will flash to show the charge level, and the power level light below the bubbler will begin to glow.
Press the power button twice in order to change the power level on the QOMO, and the power light beneath the bubbler will change colors to reflect the power level. Once you’ve selected your temperature, click the button once to start the heating cycle.
The power light will pulse a few times during pre-heat, then will change to a solid color to signal that it’s ready to use. Take a draw using a slow, sipping style technique for the best results.
The QOMO works best with smaller loads. We recommend loading just enough material for one session to avoid overloading the device.
Use a small amount of water in the bubbler - follow the red fill line as a guide. The best way to fill the bubbler is to remove it from the device, then use a very slight trickle of water from the tap to fill it.
A slow, “sipping” style pull works best with the QOMO. If you pull too hard, you can potentially cause the material to splash over the walls of the bucket.
Comments
0 comments
Article is closed for comments.