How To Use Dr. Dabber XS Electric Dab Rig?

Load your concentrates directly on the bottom heating plate for best results. You may load up to 1/2 the e-Chambers capacity, but we recommend a rice-sized amount at a time for most users. 

1. Fill the glass attachment with water using the included silicone funnel and attach it to the XS Dab Rig unit. Fill from the down stem, not the mouthpiece. When installing glass, make sure to hold the connection port and not the bridge or water chamber to avoid damage.

2. Install carb cap seal and tether to glass attachment. 

3. Prepare your product and load the e-Chamber directly on the bottom heating plate. Place the carb cap on the glass attachment.

4. Turn the unit on (5 clicks), select the heat setting (3 clicks), and depress the power button for 3 seconds to start a heating cycle. The unit will vibrate once the heating cycle has started and will illuminate RED while heating, then it will vibrate again and illuminate GREEN notifying you that optimal temperature has been reached and the unit is ready to start your hit. Take long, slow drags for best results. 

5. Remove the carb cap to clear the glass attachment. Enjoy Vapor! 

*Do not force the threading of the e-Chamber onto the main unit, it should thread on smoothly. Forcing the threading may cause cross-threading and damage the e-Chamber and/or unit.*

The e-Chamber should be completely threaded down onto the unit, about finger tight, to avoid residue getting in the connection port.

Take long, slow drags for best results. Flutter your finger over the air intake hole on the carb cap to increase or decrease the resistance of the pull.    

 Do not dry burn e-Chambers. This will help extend the life and flavor of these parts. There should always be a small amount of oil in the e-Chamber while in use. Your e-Chambers will begin to season over time, allowing them to produce more vapor with less concentration. E-Chambers are not covered under warranty as they are disposable components and will need to be replaced over time. We recommend between 4-12 months depending on usage and cleaning habits.  

Changing your e-Chamber is simply just another part of successful e-Rig care. Here are some signs that your e-Chamber may need to be changed:

• It is visually dark or damaged.
• The dish is cracked or broken
• You are experiencing a “burnt” taste, even after thoroughly cleaning your device and e-Chamber.
• Your e-Chamber is having leakage issues.
• You are experiencing decreased vapor production.